Synchronizing statuses using a desktop computer

In some cases updating the board using a desktop computer is a preferred and a better way of synchronizing the digital and physical boards. Here is how to do it.

In order to access the board scanner, firstyou need to navigate to the very board which you want to synchronize. When there, please select Agile Cards → Synchronize physical task board option. This process is similar to the first steps you have performed while setting up the physical board.

You will be presented with a dialog. Make sure to select the tab called "Field update scanner". The screen shall contain one button for uploading the board's photo. The dialog is also equipped with a board's QR code should you decide to perform the scan using a mobile device. Press the button labeled "Select photo" and select the photo file from your computer's folders.

You need to have the photo prepared prior to the actual synchronization. It is best to use the digital camera with sharp lenses and low distortion. While making the photo please follow a few simple guidelines:

• Place yourself right in front of the photographed board. The less the perspective skew the easier it will be for the scanner to operate.
• Make sure the board is lit evenly.
• Arrange the cards and splitters in such a way that the KR codes are not obscured in any way and are completely visible.
• Get as close to the board as possible, so that as much as camera's sensor resolution is used.

As soon as the photo is provided the scanner will start processing the board. Wait until the scanner finishes.

When ready it will show the summary screen with card's identifiers on top of your scanned photo as well as details provided further down the page. The identifiers shownin green, such as KTP-2 indicate cards, which have not been moved on the physical board and thus do not require status update. The identifiers shown in yellow, such as KTP-6 indicate cards, which have moved to a new position on the physical board since the last synchronization. You may also see errors in red in case the scanner has problems identifying the cards.

When ready, press the "Update board" button and the cards will be moved in JIRA automatically based on their positions identified by the Agile Cards Scanner.