How to use disableHook action in Bitbucket Command Line Interface

This article explains how to disable a hook in a Bitbucket repository using Command Line Interface (CLI)

Instructions

Using the disableHook action, a pre-receive or post-receive hook can be disabled from a repository of Bitbucket.
```
--action disableHook --project "PROJ" --repository "repo-1" --hook "Reject Force Push"
```
In above CLI action,
- --project value refers to Project key, name, or id.
- --repository value refers to Repository slug, name, or id.
- --hook value refers to Hook name or key of the form 'plugin key:hook key'.
To check the status of the hook, navigate to Repositories → Repository settings → Hooks. The hook will be disabled as shown in the screenshot below:

It is recommended to test this scenario in a non-production environment or run the action with the --simulate parameter to verify the behavior before deploying.