Introduction
This guide walks you through the process of adding or removing an issue type-to-mapping configuration.
...
Adding an issue type-to-mapping configuration
Go to
...
...
Fill in the form at the bottom of the page with the fields as defined below and
...
click Add:
Issue Type:
...
The issue type. This can be a specific issue type or an "All unassigned issue types" which is used by default for all issue types which does not have mapping explicitly configured for it.
Mapping:
...
The mapping to use with the issue type, as configured in the Mapping configurations (
...
see Configure Mappings).
...
The new issue type-to-mapping configuration will be
...
added to the list that is displayed on the same screen.
...
titleColor | #f26522 |
---|---|
title | Page Contents |
...
Removing an issue type-to-mapping configuration
Tip |
---|
Take note that there are no confirmation screens so be careful when deleting issue type-to-mapping configurations. |
Go to the Mapping Scheme Configuration Interface.
Click Remove next to the configured issue type to mapping configuration that you would like to delete.
The screen will refresh with the configuration removed.